cathode and anode electrode handle cutting machine
5.0
Read 172 reviewsThis machine is used for pouch polymer lithium battery cathode and anode pole handle (before tab welding ) cutting, or after tab welding, welding end excess metal tape cutting. The positioning plate on both sides of the battery can be adjusted left and right according to the width of the batte
17 people are viewing this right now
This machine is used for pouch polymer lithium battery cathode and anode pole handle (before tab welding ) cutting, or after tab welding, welding end excess metal tape cutting. The positioning plate on both sides of the battery can be adjusted left and right according to the width of the battery, which can adapt to the location of lithium battery with different widths. The positioning plate of the cutting length of the battery tab can be adjusted before and after, and the cutting length of the battery tab can be adjusted.
Equipment features :
Battery side positioning board can be adjusted left and right according to battery width. It can adapt to different width of lithium battery tab cutting.
Battery tab length positioning plate can be adjusted before and after, and battery tab cutting length can be adjusted.
The bottom has a waste collection box, which can collect cut battery tab waste.
The front of the cutter has a safety protection device. Safe operation.
Equipment parameters:
Minimum reservation length for tab welding end: 2 mm
Battery tab width :2-60 mm.
Battery tab centre distance :4-150 mm.
Battery tab thickness :0.1-0.3 mm.
Battery width :20-250 mm.
Equipment efficiency :800-1500 pcs/h.
Equipment gas source: ≥0.5MPa
Equipment power: AC220V, 20W.
Equipment size: 200x200x260mm